|
Rudder Position Indicator
Awareness of the rudder angle is an important safety factor. This is especially true while moving in and out of your berth, drawing alongside another boat, picking up a skier, mooring, or any other "close call" situation. Davis' Rudder Position Indicator gives instant visual reference of rudder angle.
The pointer swings a full thirty degrees with each revolution of the wheel. Mounts directly to your hub (approximately 2" (5 cm) in diameter) with a self-adhesive pad . Rugged, hermetically sealed, weatherproof, and sunproof housing ensures long life. No cables, adjustments, or electricity required; gravity power makes it simple and service-free. Suitable for boats with mechanical and single station hydraulic steering systems.
|
26.26 |
|
|
MK5 Rudder Angle Indicator
The Ruddermaster indicates at a glance how far the rudder is from a straight-ahead position. As the steering wheel is turned, the sending unit communicates the angle of the rudder to the calibration box. The calibration box transmits the rudder’s position to the meter.
The Ruddermaster can be used both as a steering aid and to monitor auto pilot systems. Raritan offers several styles of meters for readout as well as some that are splash proof. Repeating units can also be installed should there be a need for a readout at a station and not the main control panel.
Features:
Ready for installation with all necessary components needed - meter, calibration box and sending unit
Constant monitoring of rudder angle position from 0°-45°
Great aid for docking or close maneuvering
Each unit is assembled by hand, individually tested and backed by Raritan's 1-year Limited Warranty and legendary technical support team
Repeater units are available for multiple station readouts
Rudder Indicator with 4-1/2" flush mount panoramic meter
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
|
695.12 |
|
|
3-3/8" (85MM) ViewLine Rudder Angle Indicator -45°/+45° - 8 to 32V - Black Dial & Bezel
The ViewLine rudder angle instrument for wheel-controlled yachts and pleasure boats displays the current rudder position at all times. This indicator makes it easier to navigate out of harbors or through locks.
Only rudder instruments of the same diameter can be combined.
Specifications:
8 and 14 pole Tyco / Hirschmann bush housing
Operating voltage 8 – 32 V
Accuracy +/- 2.5 % of full scale reading
Anti-fog double lens
Protection rating front IP67, rear IP52
85 mm installation diameter
50 mm installation depth
Operating temperature range -20 °C / +70 °C
Reverse polarity protection
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
76.37 |
|
|
3-3/8" (85MM) ViewLine Rudder Angle Indicator -45°/+45° - 8 to 32V - White Dial & Bezel
The ViewLine rudder angle instrument for wheel-controlled yachts and pleasure boats displays the current rudder position at all times. This indicator makes it easier to navigate out of harbors or through locks.
Only rudder instruments of the same diameter can be combined.
Specifications:
8 and 14 pole Tyco / Hirschmann bush housing
Operating voltage 8 – 32 V
Accuracy +/- 2.5 % of full scale reading
Anti-fog double lens
Protection rating front IP67, rear IP52
85 mm installation diameter
50 mm installation depth
Operating temperature range -20 °C / +70 °C
Reverse polarity protection
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
76.37 |
|
|
Analog Rudder Angle Indicator
The analog rudder angle indicator is a backlit 76mm (3in) gauge displaying the actual position of a vessels rudder. All ComNav Autopilots come with built in electronics to drive at least three meters without additional interfacing.
Features:
Flush mount
Water resistant front face
Supply voltage for lighting 12-32VDC
|
610.96 |
|
|
ViewLine 52mm (2-1/16") Rudder Angle Indicator - 40° Port/Starboard
The ViewLine rudder angle gauge for wheel-controlled yachts displays the current rudder position at all times. An important cockpit gauge for accident-free maneuvers in narrow waterways.
Features:
8 pole Tyco/Hirschmann bush housing
Operating voltage 8–32 V
Current consumption <150 mA • Anti-fog double lens
Front side protection rating IP67
52 installation diameter
50 mm installation depth
*Sold as an Individual Piece
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
46.60 |
|
|
Professional 85MM (3-3/8") Rudder Angle Indicator for NMEA 0183
Specially designed to fit into the standard 85mm panel cut, the Professional Rudder Angle Indicator is developed to suit commercial applications thanks to the embedded NMEA 0183 transceiver - which makes it operable with most of the professional autopilots out in the field - and the large 270° dial scale and Red illumination which makes it well readable and accurate in the indication.
It supports both 12V and 24V systems, and it is designed to resist the harshest environment thanks to its extended operating temperature from -30°C to +80°C and IPX7 protection class.
Able to support the analogue 3-180 Ohm and 0-5V rudder sensors, the Professional Rudder Angle Indicator also repeats the rudder angle data via NMEA 0183 to multiple gauges connected in series to it.
The embedded infrared (IR) pushbutton allows for a user-friendly fine tuning of the predefined calibration.
Features:
Designed for NMEA 0183
Easy programing and installation
Technical Specifications:
Operating Voltage - 8 to 32 V
Protection Class - IP6K7
Illumination - Red LED
Dial - Black w/graphics
Pointer - Red Illuminated
Lens - Plastic Double Lens (anti-reflective)
Operating Temp. - -40°C to 115°C
Connector - Molex MX150 - 12 pin
In the Box:
Gauge
Wire Harness
Mounting Spinlock
Safety Instructions
*Sold as an Individual
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
200.88 |
|
|
Stand Alone Rudder Angle Indicator System
Complete single station RAI system typically used on vessels that do not have a ComNav autopilot or, in cases where a separate RAI system is required (such as Hydraulic Full Follow-up steering systems). The Stand Alone System consists of three components:
ComNav Rudder Follower w/50' cable and linkage kit
RAI Distribution Box w/special circuitry
ComNav 3" Rudder Angle Indicator
|
1570.81 |
|
|
Rudder Angle Indicator Watertight Case
The Rudder Angle Indicator Watertight Case is a good alternative for outdoor applications where flush mounting the RAI may not be possible. In these cases or, when the back of the RAI may be exposed to moisture, we recommend the watertight case. The kit comes complete with case, O-ring seals, screws and two watertight cable glands.
|
169.91 |
|
|
Newport SS 2" Rudder Angle Indicator Gauge
The Newport Stainless Steel (SS) family of marine gauges is a classic style of gauge, engineered to be the new Modern Retro.
Designed with the latest fog resistant features, this Retro Style gauge far surpasses all expectations. Perimeter lighting makes reading these gauges easy to read Day/Night.
Features:
Perimeter lighted Retro White Dial
Black and Gray Graphics
Domed fog resistant lens
Two-piece Black pointers
Hand-polished Stainless Steel bezel
Studded connection for ring terminals
Red illuminated edge-lighting
Technical Specifications:
Operating Range - Port to Starboard
2.06" (53 mm) Mounting hole
Operating Voltage - 12/24 V
In the box:
Gauge
Mounting Hardware
Installation Manual
Factory P/N GP8186
*Sold as an Individual
**Gauge Cover not Included
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
58.97 |
|
|
Chesapeake White SS 2" Rudder Angle Indicator Gauge
Perimeter-lighted White dial with stylish Blue and White graphics, polished stainless steel bezel, contoured White pointer and domed glass lens.
2"- Hole Size: 2.0625" (53mm)
Specifications:
Anti-scratch glass lens
Plastic Cases for corrosion resistance and long life
12 VDC Negative Ground
Can be adapted for 24 VDC systems
Factory P/N GP7378
*Sold as an Individual
**Gauge Cover not Included
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
54.48 |
|
|
Chesapeake Black 2" Rudder Angle Indicator Gauge
Perimeter-lighted Black dial with stylish Blue and White graphics, polished stainless steel bezel, contoured White pointer and domed glass lens.
Specifications:
Anti-scratch glass lens
Perimeter lighted back light
12 VDC negative ground
Can be adapted for 24 VDC systems
Factory P/N GP7377
*Sold as an Individual
**Gauge Cover not Included
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
52.37 |
|
|
Euro Black 2" Rudder Angle Indicator
Perimeter-lighted Black dial with bold White graphics, Black aluminum bezel, contoured White pointer and flat glass lens.
2" - Hole size: 2.0625" (53mm)
Specifications:
Anti-scratch glass lens
12 VDC negative ground
Perimeter-lighted Black dial
Can be adapted for 24 VDC systems
Factory P/N GP7373
*Sold as an Individual
**Gauge Cover not Included
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
42.76 |
|
|
Dual Actuator Marine Hardware Pack
High quality dual actuator hardware kit. This hardware bag is required in order to install hydraulic dual actuator systems. Includes: additional pipe nipples and brass "T" fittings.
This product may not be returned to the original point of purchase. Please contact the manufacturer directly with any issues or concerns.
|
32.40 |
|
|
Marine / Boat Hardware
We offer a full selection of marine hardware, including anchor rollers, anodes, ski tows, vents, and more. If you have a boat and need hardware, you are in the right place. From chocks and cleats to shaft seals and steering wheels, you can count on us for your boat hardware needs. It can sometimes be difficult to find everything you need for your boat, especially all in one place, but our full service site gives you plenty of excellent options for all the hardware you will need for your boating excursion.
Bow & stern eyes, deck fills, deck plates, and engine mounts are all available here, along with gas springs, grab handles, and hatches. We also have a wide assortment of hinges, hooks & clamps, and latches so you can find just the right option for your boat. With oarlocks, rail fittings, rub rail, shaft couplers, and swim platforms, as well as a selection of rope & chain pipe, you can find the things you need the most. We also have a selection of marine lumber, including teak. By using teak lumber for your marine needs, you have a great wood look that will hold up to the elements, and you can get it right here with all your marine hardware.
|
|