Deck Mount Stabilizer Kit Use this to stabilize your Force® Kraken Trolling motor when in the stowed position.

MKA-50 Bow-Mount Stabilizer Kit for Fortrex Features: Reduces motor bouncing when in stowed position Attaches to the left or right side of bowguard Pivots into vertical position and rests on the boat deck when motor is stowed Rotates in the horizontal position with bowguard when the motor is deployed Includes rubber bumper to protect deck finish Stainless steel hardware tested for saltwater use Fits any Fortrex or Riptide SF bow-mount trolling motor WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

As the Fall months creep into our calendars, boat owners in cooler climates acknowledge, with sadness, that it’s time to put the boat away. Outside Storage? It’s a thought and an option but consider that you may be threatened by snow build up, tornadoes or hurricanes. The success of storing your boat outside depends on how well your boat is protected from the conditions outdoors.                          Rinse/Flush Rinsing the outside of your boat and trailer thoroughly with fresh water will remove excess salt. Pay particular attention to your trailer’s leaf springs, wheel hubs and brakes that are constantly submerged during launching and retrieval of your boat. Flush your engine's cooling system with fresh water in line with your engine manufacturer’s salt removal recommendations. This will minimize corrosion and overheating issues come spring. Drain your boat of all water – bilge, head, sink lines, water tanks, sea-cocks, and pipes. If you are in an area with extended periods of freezing, put antifreeze in the low parts if there is still some water present. Salt Watch out for salt. Buy a good salt remover to minimize corrosion. Add fuel stabilizer to top off your fuel tanks. Here is one recommended by CLR Marine. Diesel Formula Fuel Stabilizer & Performance Improver - 32oz *Case of 4* STA-BIL Diesel Formula Fuel Stabilizer is a diesel additive that keeps fuel fresh for quick, easy starts and maximized for engine performance. Designed for use with all diesel engines, and all diesel fuels, Sta-Bil Fuel Stabilizer Diesel formula prevents sludge and sediment formation, cleans and lubricates fuel injectors to improve performance and helps remove water. It is safe to use and recommended for use at every fill up, with the 32 ounce bottle treating up to 320 gallons of fuel. Batteries Remove the batteries from your boat and store in your garage or basement. Batteries should be connected to a battery charger that will give them a good charge and one that w automatically switches to a float/trickle charge to keep your batteries topped up. Match your charger to the type of battery you are charging. Using a charger manufactured for lead acid batteries to charge an AGM (absorbent glass mat) battery will cause damage to the battery. If you choose to keep your batteries in the boat, connect a solar trickle charger. These chargers will keep your batteries topped off without the hassle of removing heavy batteries from your boat. Cleaning Clean the exterior with the proper fiber glass or wood cleaner needed for your boat. Bright work can be cleaned by removing the wood or cleaning it as it is - installed. Be careful to not get the wood cleaner onto the deck surfaces. The exterior should be dried with a chamois cloth. Vinyl seat cushions and backs should be cleaned with vinyl cleaner. Hard surfaces inside the vessel can be wiped with all purpose cleaners. End your cleaning with a coat of wax to the exterior and polish. Don’t forget the bottom paint. Before you store, spend the time to give your boat a thorough cleaning. CLR Marine has many products by trusted brands such as Powerhouse, Davis Instruments, Jabsco, Shurhold, and Swobbit, to help winterize and clean. You will be grateful in the spring during launch time that your boat is already clean as the new boating season begins. Cover Up If you store outside in your yard, driveway, or a boat yard, a boat cover is a must to prevent damage from winter conditions. Leaving your boat in the water is not recommended. The boat is exposed to rough weather, and has a greater possibility of sinking if you aren’t monitoring it often. https://www.clrmarine.com/462m4/boat-outfitting/winter-covers.html and https://www.clrmarine.com/462m4/winterizing.html Circle May 21, 2022, on your calendar. The date is almost ten days before Memorial Day, next year when most harbors open for the season. Start your prep work, tune-ups, sanding, and painting to get out on the water and a great boating season. In the meantime, during the cold winter months, cozy up to the fire and read your boating manuals, new safety regulations and weather information. Fair winds and smooth sailing.   To obtain more information about the products and services mentioned in this article, please get in touch with CLR Marine https://www.clrmarine.com/. _________________________________________________________________________ Award-winning author Cheryl Kuba has been at the helm for more than 30 years sailing the Great Lakes, with side trips to the British Virgin Islands and St. Maarten. She has served as past- Commodore of Great Lakes Fleet 21 -Chicago region. 3happycampers.com ©Copyright Cheryl Kuba, 3happycampers.com, 2021.  

MKA-60 Stabilizer Kit Reduces bounce on bow-mount trolling motors. Equipped with a low profile mounting base that allows the stabilizer to be easily removed. The pivoting arm can be folded down when not in use. Features: Reduces motor bounce in the stowed position Absorb vibrations to protect the motor shaft Folds down when not in use Multiple mounting orientations to fit your boat configuration Easily removable, it leaves only a low-profile base Stabilizer shafts can be cut to fit Multi-position strap adjusts to accommodate all shaft sizes Includes Stainless steel mounting hardware Compatible with the QUEST series RT Instinct, Ulterra, RT Terrova, Terrova, and Ulterra, Riptide Ulterra, Terrova, Riptide Terrova, Riptide ST, PowerDrive, Riptide PowerDrive, PowerDrive V2, Riptide SP, and PowerDrive Pontoon

Float Tube Adapter 266 Mounting straps and brackets for use with No. 241 Combination Side/Deck Mount or 241L Locking Combination Side/Deck Mount These adjustable wrap-around straps are quick and easy to release from your float tube or pontoon boat Includes 2 brackets, 2 mounting straps and hardware (Combination Side/Deck Mounts not included) For use with No. 241 side/deck mount (No. 241 not included) WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Deck Mount 22.5° Angle Electronics Mount Secure most fishfinders and sonar/GPS up to 16 in. on most casting decks. Designed to mount over recessed trolling motor foot control pedals to more freely operate the pedal and free up deck space for rod butts. Features a 22.5° angled plate. Best suited for decks with less space forward of the foot pedal, allowing more aft foot clearance over the pedal. Fits most major electronics brands. Spans most recessed foot pedals. Powder-coated, marine-grade aluminum construction. Inside Span: 14.1 in. Features: Secure most fishfinders and sonar/GPS up to 16 in. on most casting decks Designed to mount over recessed trolling motor foot control pedals to more freely operate the pedal and free up deck space for rod butts Features a 22.5° angled plate Best suited for decks with less space forward of the foot pedal, allowing more aft foot clearance over the pedal Fits most major electronics brands, spans most recessed foot pedals

Deck Mount Flat Electronics Mount Secure most fishfinders and sonar/GPS up to 16 in. on most casting decks. Designed to mount over recessed trolling motor foot control pedals to more freely operate the pedal and free up deck space for rod butts. Fits most major electronics brands. Spans most recessed foot pedals. Powder-coated, marine-grade aluminum construction. Inside Span: 14.1 in. Features: Secure most fishfinders and sonar/GPS up to 16 in. on most casting decks Designed to mount over recessed trolling motor foot control pedals to more freely operate the pedal and free up deck space for rod butts Fits most major electronics brands Spans most recessed foot pedals Powder-coated, marine-grade aluminum construction

Antenna Under Deck Mount Mount your antenna under a fiberglass surface with this under deck mount. WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Stainless Steel Quick-Release Hose Deck Mount Fitting & Hose Adapter Stainless Steel Deck Mount Fitting, 1/2" NPT Female Inlet, 3/4" GHT Male Hose Adapter. The Quick Release Connector provides the perfect installation solution for your HoseCoil washdown or garden style hose. The Quick Release installs easily on your boat and allows you to stow your hose out of the way. Never trip on a hose again! This clever design will allow you to flush mount the Quick Release into your cockpit or bulkhead. WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

Swivel Fishfinder Mount 269 Includes No. 241 Side/Deck Mount Uses the Scotty post mount design for quick removal and infinitely adjustable rotation. Fits or can be adapted to most fishfinder brands including Lowrance, Eagle Humminbird and Garmin. WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more information go to P65Warnings.ca.gov.

1-Mile Deck Mount, Bi-Color Red/Green Combo Sidelight - 12V - Stainless Steel Housing Part #: 66318-7 Constructed of corrosion-resistant 304 stainless steel, these lights provide one-mile visibility for power boats up to 39.4 ft. (12 meters). Lights include rubber gasket lens seals for enhanced internal corrosion-resistance. Includes one 7.5 watt lamp. For connection to 12 VDC power supply. Installs with three #6 mounting fasteners (not included) . Provides 1-mile, 225 degree light visibility. Features: 1-Mile Bi-Color Red/Green Combination 225 Degree Stainless Steel Housing WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

NaviLED Deck Mount Port & Starboard Pair - 2nm - Clear Lens/White Housing Compact deck mount LED navigation lamps.  Attractive, power saving and ultra reliable. Ultra low current draw NaviLED® lamps use less than 10% of the power required to run a bulb navigation lamp of the same visible distance. Port and Starboard lamps consume less than 2W combined! No bulbs, No maintenance, Ultra long service life Hella marine LED technology has no filaments to break making NaviLED® lamps extremely shock and vibration proof for proven reliability and safety in demanding conditions. Multivolt™ 8-28V DC Advanced electronics ensure reliable illumination and lamp protection even under severe voltage fluctuations and low battery voltages. Safe and highly visible Hella marine optics deliver 100% correct light output and enhanced visibility compared to bulb navigation lamps. Fully sealed for life. IP 67 certified Each NaviLED® lamp is a completely sealed unit. High impact housings ensure durability from waves and impact. Specifications: Material Description: UV resistant, enhanced impact resistant acrylic lens High impact shroud Minimum Visible Distance: 2 Nautical Miles (Yachts and Powerboats) Cable: Pre-wired with 500mm of twin core marine cable Operating Voltage: Multivolt 8-28V DC Voltage Protection: Spike protected to +500 volts. Reverse polarity protected to -700 volts Power Consumption: Port and Starboard less than 2W combined Degree of Protection: IP 67 - Completely Sealed Weight: 75g (including cable) Approvals:  IMO Col Reg 72, RINA, USCG, ABYC A-16, Maritime NZ

LightArmor Deck Mount Navigation Light - Stainless Steel - Port (red) - 2NM INTRODUCING LIGHTARMOR NAVIGATION LIGHTS, a new line of streamlined deck mount lights that meet today's global regulatory requirements, including EN/ISO 19009:2015.* LED Light Engine Cool to the touch Long lasting - 50,000+ hours Color indicated cores for ease of installation Be Safe, Be Seen Sharper cut-off angles and vibrant starboard and port colors for better visibility 2 NM U.S.C.G. Certified Corrosion Resistant Water-Resistant (IP Rating 67) Features tell-tale indicators for ease of use Smaller footprint with refined styling WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

LightArmor Deck Mount Navigation Light - Stainless Steel - Starboard (green) - 2NM INTRODUCING LIGHTARMOR NAVIGATION LIGHTS, a new line of streamlined deck mount lights that meet today's global regulatory requirements, including EN/ISO 19009:2015.* LED Light Engine Cool to the touch Long lasting - 50,000+ hours Color indicated cores for ease of installation Be Safe, Be Seen Sharper cut-off angles and vibrant starboard and port colors for better visibility 2 NM U.S.C.G. Certified Corrosion Resistant Water-Resistant (IP Rating 67) Features tell-tale indicators for ease of use Smaller footprint with refined styling WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Signature Series 3 Wake Tower Mounting Bracket - Deck Mount Versatile mounting solution for Signature Series wake tower speakers. Features: Quick and simple to install UV stable salt fog-resistant aluminum alloy design  Technical Specifications: Fixed (non-swivel) Dimensions (W x H x D) - 4.84" x 3.31" x 2.36" (123 x 84 x 60 mm) In the Box: Two (2) Deck mount wake tower brackets Mounting hardware  Documentation *Sold as a Pair WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.