|
Flotec FP3212 3-Wire 4 Inch Submersible Well Pump, 230 Volts 1/2 HP, 10 GPM
4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use.
KEY FEATURES
For 4" inside diameter or larger wells
Pumps from depths of 150ft
Floating Stack Design for sand resistance and reduced sand locking
Corrosion-resistant stainless steel pump and motor housing
3 year limited warranty
HORSEPOWER: 1/2
PERFORMANCE SERIES: 10 GPM
VOLTAGE: 230v, 60 Hz
NUMBER OF WIRES: 3 plus ground
BODY CONSTRUCTION: Stainless steel
MAXIMUM CAPACITY: 14 GPM
OPERATING RANGE: 20' to 150'
MAXIMUM DEPTH-TO-WATER: 150'
MAX PSI: 105 psi
PUMP DIAMETER: 3.78"
DISCHARGE PIPE SIZE: 1-1/4" NPT
RECOMMENDED BREAKER: 10 amp
|
588.75 |
|
|
Flotec 3-Wire 4 Inch Submersible Well Pump, 230 Volts 1.5 HP, 10 GPM
4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use.
KEY FEATURES
For 4" inside diameter or larger wells
Pumps from depths of 300ft
Floating Stack Design for sand resistance and reduced sand locking
Corrosion-resistant stainless steel pump and motor housing
WARRANTY
3 year warranty
HORSEPOWER: 1-1/2
PERFORMANCE SERIES: 10 GPM
VOLTAGE: 230v, 60 Hz
NUMBER OF WIRES: 3 plus ground
BODY CONSTRUCTION: Stainless Steel
MAXIMUM CAPACITY: 16 GPM
OPERATION RANGE: 40' to 300'
MAXIMUM DEPTH-TO-WATER: 300'
MAX PSI: 170 psi
PUMP DIAMETER: 3.78"
DISCHARGE PIPE SIZE: 1-1/4"
|
1510.56 |
|
|
Flotec FP2211 2-Wire 4 Inch Submersible Well Pump, 115 Volts 1/2 HP
4" Submersible Pumps are the most economical, energy-efficient pumps for 4" wells or larger. They provide the optimum amount of water and pressure for general home and farm use.
KEY FEATURES
For 4" inside diameter or larger wells
Pumps from depths of 150ft
Floating Stack Design for sand resistance and reduced sand locking
Corrosion-resistant stainless steel pump and motor housing
WARRANTY
3 year limited warranty
HORSEPOWER: 1/2
PERFORMANCE SERIES: 10 GPM
VOLTAGE: 115v, 60 Hz
NUMBER OF WIRES: 2 plus ground
BODY CONSTRUCTION: Stainless Steel and Thermoplastic
MAXIMUM CAPACITY: 13.6 GPM
OPERATION RANGE: 20' to 150'
MAXIMUM DEPTH-TO-WATER: 150'
MAX PSI: 105 psi
PUMP DIAMETER: 3.78"
DISCHARGE PIPE SIZE: 1-1/4" NPT
RECOMMENDED BREAKER: 25 amp
|
573.75 |
|
|
Flotec Stainless Steel Waterfall Utility 1/2 HP
Stainless Steel construction with a ceramic seal design marks the FPOS4100X as the top of the line in the Flotec Waterfall/utility series of pumps.
KEY FEATURES
Complete stainless steel construction - superior corrosion resistance
Seal design - allows for continuous operation
High performance - ideal for waterfalls and streams
WARRANTY
2 year limited warranty
BODY CONSTRUCTION: Stainless Steel
HORSEPOWER: 1/2
MAXIMUM LIFT: 30'
MAXIMUM CAPACITY: 4100 GPH
FLOW at 10' LIFT: 3000 GPM
SWITCH TYPE: No Switch (Manual Operation)
DISCHARGE PIPE SIZE: 1-1/4" (ships with Adapter Fittings)
AMP DRAW (full load): 7.2 Amps
CORD LENGTH: 15'
VOLTAGE: 115v AC, 60 Hz
MAXIMUM WATER TEMPERATURE: 100°F (38°C)
|
681.75 |
|
|
Flotec FP217-811 Control Box for 3/4HP Pumps
For use with Flotec Submersible Sump Pump, Model FP3222
Controls the start and run functions
|
144.69 |
|
|
Flotec FP003415S Brush Kit For F360AC
Flotec Brush Kit for Flotec FP0F360AC Cyclone Pump and Simer M-40, M40 Pump. Fits Pumps with Square Front Covers Only.
Flotec, Simer and Sta-Rite parts are interchangeable. The Brand name does not matter, only the part number must be the same
|
52.92 |
|
|
Flotec FP4122 Well Pump 3/4Hp 115/230V
Flotec Shallow Well Jet Pump, Cast Iron Construction, 3/4HP 115/230V, 1-1/4”NPT Suction x 1” NPT Discharge Ports, up to 14.4GPM at 40psi, Pressure Switch Set to 30psi On / 50psi Off, up to 25 Foot Water Depth
|
720.00 |
|
|
Flotec FP2122 Submersible Well Pump 4"
Flotec Submersible Well Pump, for 5" or Larger Wells, Stainless Steel Pump and Motor Housing, 7GPM Series, 2 Wire, 3/4HP 230V, 1-1/4”NPT Port, Water Filled Submersible Motor, Built-in Check Valve, No Control Box Required
|
650.30 |
|
|
Jabsco 53041-2003-230 Pump 230V 50Hz
Heavy Duty Utility 1" Self-Priming Flexible Impeller Pump
230 volt, single phase, 50Hz IP54 Electric Motor, Nitrile oil-resistant impeller
Connections: 1” BSP internal threaded ports
Output: up to 9.5 GPM
Built-in dry-running protection for up to 30 minutes after initial prime
Rapid self-priming from dry up to 2m
Will handle hard or soft solids
Corrosion resistant bronze body, stainless steel shaft
Carbon-ceramic mechanical shaft seal
Simple, fully serviceable design with few wearing parts
Continuously rated motor
|
1274.63 |
|
|
Flotec FP2112 Submersible Well Pump 4"
Flotec Submersible Well Pump, for 5" or Larger Wells, Stainless Steel Pump and Motor Housing, 7GPM Series, 2 Wire, 1/2HP 230V, 1-1/4”NPT Port, Water Filled Submersible Motor, Built-in Check Valve, No Control Box Required
|
512.29 |
|
|
Gianneschi MAXI SUB Bilge Pump 230/50
Submersible Bilge Pump for seawater and grey water.
Maxi Sub
230v 50 Hz - 0,18 kW
Max flow: 180 L/min @ 2 m
Max head: 8 m @ 30 L/min
Outlet: 1", female (vertical)
Stainless steel shaft (AISI 316) ; ABS open impeller
Diameter: 230 mm
Height: 350 mm
IP rating : IP68
|
504.36 |
|
|
Flotec FP4312 Thermoplastic Convertible Jet Pump 1/2 HP
Corrosion resistant convertible jet pumps are constructed of rugged fiberglass-reinforced thermoplastic, and assure years of dependable service.
KEY FEATURES
Superior performance at depths to water of 100' or less
Fiberglass-reinforced thermoplastic pump housing for the highest corrosion resistance
Ready-to-install dual voltage motor preset to 115v - see manual for 230 volt conversion
WARRANTY
1 year limited warranty
BODY CONSTRUCTION: Thermoplastic
HORSEPOWER: 1/2
MAXIMUM CAPACITY: 9 GPM (shallow well setup)
FLOW AT 10' LIFT and 40 PSI: 7.8 GPM (shallow well setup)
MAX LIFT: 25' w/ shallow well jet kit / 70' w/ deep well jet kit
MAX PSI: 62 psi (shallow well setup)
PRESSURE SWITCH SETTING: 30/50
SUCTION PIPE SIZE: 1-1/4"
MINIMUM SUCTION PIPE SIZE: 1-1/4"
DRIVE PIPE SIZE: 1"
DISCHARGE PIPE SIZE: 1"
MINIMUM DISCHARGE PIPE SIZE: 3/4"
AMP DRAW: 9.9 Amps on 115V / 4.95 Amps on 230V
VOLTAGE: 115v/230v, 60 Hz (factory preset to 115v)
RECOMMENDED BREAKER: 15 amp
MAXIMUM WATER TEMPERATURE: 140 F (60 C)
|
516.00 |
|
|
Little Giant 230V Submersible Sump Pump 506266
Little Giant 6-CIM Submersible Sump Pump 230 Volt
Motor 230 Volt 60 Hz 1/3 HP Permanently Lubricated Oil Filled Continuous Duty Motor, 46GPM at 5 Foot Head, Shutoff Head 18 Feet, Inlet: Screened, Outlet: 1-1/2" FNPT with 1-1/4" Adaptor, Epoxy Coated Cast Iron Housing, Polypropylene Body, Mechanical Seal, Manual Operation, 12 Foot Power Cord- No Plug
506266 For residential and light commercial use, the submersible sump pump provides efficient and reliable service.
|
375.18 |
|
|
Flotec Portable Utility Booster Pump
Manages a variety of home applications including sprinkling, pressure boosting and dewatering.
Can be used as a portable sprinkler pump
Ideal for boosting pressure to wash cars, boats and farm equipment
115V air cooled motor and has a 1 year limited warranty
BODY CONSTRUCTION: Thermoplastic
HORSEPOWER: 1/2 HP
MAXIMUM PRESSURE: 62 PSI
MAXIMUM CAPACITY: 10.3 GPM
FLOW at 10' SUCTION LIFT and 30 PSI: 5.1 GPM
SWITCH TYPE: No Switch (Manual Operation)
SUCTION SIZE: 1" (ships with garden hose adapter)
DISCHARGE SIZE: 1" (ships with garden hose adapter)
MAXIMUM SOLIDS HANDLING SIZE: .06"
AMP DRAW (full load): 7 Amps
CORD LENGTH: 6' w/ 3-prong grounded plug
VOLTAGE: 115v AC, 60 Hz
|
386.88 |
|
|
Flotec FP5512 Cast Iron Centrifugal Pump 1/2 HP
Economical, general purpose centrifugal pumps can be used for water transfer, circulation, fountains, waterfalls, pressure boosting and sprinkling.
FEATURES
Superior performance at depths to water of 25' or less
Rugged, heavy-duty cast iron pump housing
Ready-to-install 230 volt motor (dual voltage)
WARRANTY
1 year limited warranty
BODY CONSTRUCTION: Cast Iron
HORSEPOWER: 1/2
MAXIMUM CAPACITY: 22 GPM
MAX LIFT: 25'
MAXIMUM DISCHARGE PRESSURE: 36 psi
MAXIMUM INLET PRESSURE:
MAXIMUM TOTAL PRESSURE:
SUCTION PIPE SIZE: 1-1/4" NPT
DISCHARGE PIPE SIZE: 1" NPT
AMP DRAW (full load): 4.7 amps on 230v / 9.4 amps on 115v
VOLTAGE: 230v / 115v , 60 Hz
MAXIMUM WATER TEMPERATURE: 140 °F (60 °C)
RECOMMENDED BREAKER: 15 amp on 230v / 15 amp on 115v
|
440.70 |
|