Mast Mount Bracket for UFO X TV Antenna High quality, stainless steel bracket specifically designed for the UFO X mast mounting. This pole has been designed mainly for the Majestic UFO when mounting on masts to allow the antenna to be easily fitted. Simply install the bracket to the side of the mast and then screw the antenna to the top height near the top of the mast. This will assist in getting the best possible signal.

SC111 PowerTower® Starboard Mounted Bar f/GPS/VHF/Navtex Antenna Mounts GPS, VHF and Navtex antennas above the radar for maximum visibility and performance.   Works with standard 1” x 14 TPI thread. Compatible with: Scanstrut aft leaning PowerTower® radar mounts Features: Designed for the installation of GPS antenna and ‘Whip’ type VHF, HF/SSB, AM/FM, and cellular antenna of up to 1m in height All mounting holes predrilled for easy retrofit installation, attach using mounting bolts.  No extra fastenings required Cables run internally via a watertight seal Technical Specifications: Material - 316 Stainless Steel Height - 12.5" (318mm) Mount Position - Starboard side In the Box: Antenna bar Instruction manual *Sold as an Individual

SC112 PowerTower® Port Mounted Bar f/GPS/VHF/Navtex Antenna Mounts GPS, VHF and Navtex antennas above the radar for maximum visibility and performance.   Works with standard 1” x 14 TPI thread. Compatible with: Scanstrut aft leaning PowerTower® radar mounts Features: Designed for the installation of GPS antenna and ‘Whip’ type VHF, HF/SSB, AM/FM, and cellular antenna of up to 1m in height All mounting holes predrilled for easy retrofit installation, attach using mounting bolts.  No extra fastenings required Cables run internally via a watertight seal Technical Specifications: Material - 316 Stainless Steel Height - 12.5" (318mm) Mount Position - Port side In the Box: Antenna bar Instruction manual *Sold as an Individual

Flat Mount Bracket f/StructureScan 3D Ducer & TotalScan Ducer 3D Transducer Flush Mount Bracket is used to flush mount the transducer under the boats Hull. Suits TotalScan and 3D Transom Transducers

Stainless Steel Mounting Bracket f/Side Mount Table Pedestal Polished stainless steel, side mount table pedestal removes when not in use for clear decks. Locking feature offers added mounting strength. Features: Polished stainless steel pedestal & table support Anodized aluminum bracket Locking pull pin offers added mounting strength Removable 125° bent leg Dimensions: 4-7/8"W x 4"H x 1/2"D Screw: #10 flat head / 1/4" hole. Benefits: Eliminates the need for mounting holes in boat deck and/or cockpit Easy to remove when not in use, for clear passage and storage Quick set-up and removal in tight spaces Increased leg & foot room

Mounting Bracket f/GO9 & Vulcan 9; NSS7 and ZEUS7 Gimbal mounting bracket for Simrad GO9 & B&G Vulcan 9; NSS7 and ZEUS7

Transom Mount Bracket f/Livescope Plus LVS34 Easily attach your compatible LiveScope™ transducer to the transom of your boat with this stainless steel mount.

1014 Mounting Bracket f/1011 12V Socket Socket not included Features: Designed to withstand the rigors of wet environments and constant vibration Large contact surfaces for good electrical connection Twist lock system - plug locks securely into socket Internal strain relief and cord seal Nickel plated copper alloy used for all current carrying components Front panel, rear panel, or surface mount WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

APT-GPS-01 PowerTower® Center Mounted Bar f/GPS/VHF/Navtex Antenna Mounts GPS, VHF and Navtex antennas above the radar for maximum visibility and performance.   Works with standard 1” x 14 TPI thread. Compatible with: Scanstrut aft leaning PowerTower® radar mounts Features: Designed for the installation of GPS antenna and ‘Whip’ type VHF, HF/SSB, AM/FM, and cellular antenna of up to 1m in height All mounting holes predrilled for easy retrofit installation, attach using mounting bolts.  No extra fastenings required Cables run internally via a watertight seal Technical Specifications: Material - Aluminum  Height - 12.48" (404mm) Mount Position - Center In the Box: Antenna bar Instruction manual *Sold as an Individual

UFO XL High Gain 15" 34dB Marine TV Antenna The Majestic UFO XL is a larger version of the current model TV Antennas. Developed with a larger and more powerful amplifier to be able to boost the smallest signal, the Majestic UFO XL is designed for Offshore and Outback performance. The Majestic engineering team understands the limitations of both the Marine and Outback environments and developed the Majestic UFO XL specifically for boats, caravans, motorhomes, buses, trucks, and RVs. Using the latest in high-tech engineering the Majestic development team was able to use the larger size and improved amplifier to create one of the most powerful TV antennas in the Marine and RV industry. You won’t find a company that develops its own TV antenna and TV which are perfectly tuned to give you the performance needed when you are in fringe areas such as boating or in the RV industry. Features: Size: The Majestic UFO XL is 38cm (15") wide and is packed with the latest in technology RF Amplifier to give you the ultimate in offshore or outback performance. It is slightly larger than the UFO X, so is it capable of picking up small signals in a larger surface area and combined with the more powerful RF amplifier ensures excellent reception.   Gain: Firstly the main engineering improvement is the boosting of the amplifier of the UFO XL which is at 34dB versus the UFOX at 30 dB. The UFO XL has a 34dB High Gain Amplifier built into the Antenna which is a 130% increase in signal performance on the UFOX. (For every 3dB Gain the signal level double). This gives you a huge advantage over other TV antennas because now you have a very strong signal in the antenna that has not had any interference being induced when it received the signal, and with a very strong signal being sent down the cable, the electrical interference is insignificant compared to the strong signal. Once the signal is sent down to the junction we do not need to do any filtering or cleaning to give you excellent digital reception.  Vertical and Horizontal: The UFO XL has had a vertical and horizontal plane incorporated to give you the performance needed in both Vertical and Horizontal locations. This feature is rarely found in TV Antennas as most are either designed to work in a Vertical or Horizontal application. For those that are looking for a TV antenna that can perform worldwide covering both vertical and horizontal, digital and analog signals then the Majestic UFO XL Marine and RV TV Antenna is the ultimate choice.  SNR: Signal to Noise Ratio. This is one of the most important factors of a TV Antenna which has an amplifier. The lower the signal to noise ratio the better the amplifier performs. Basically we are comparing Signal vs Noise. The more signal we have and the less noise we have the better the amplifier works. The UFO XL uses state-of-the-art-technology to produce a very low a signal to noise ratio of 3dB which is extremely low compared to most other brands. This means that more signal is amplified and less noise is amplified, which in turn means better performance. This also significantly improves distance performance, as the further you get the signal is weaker, and the noise of electrical interference, other noise still remains high, so the UFO XL Amplifier is able to clean the signal and give you exceptional performance.  Ground Independent: The UFO XL is also designed to be ground independent (does not need a ground plane or be grounded) to amplify the TV signal. This design is very specific as most installations do not allow for a proper RF Ground, which is totally different from an electrical ground. This is another brilliant engineering design by Majestic to make this antenna perfect for boats or any non-metal roof installation.  Voltage Range – Most Antenna brands claim they are 12 Volt, and technically yes they work on 12 Volts. However, the issue is the level of tolerance that most of these Antenna have, most 12 Volt TV antenna have a limited tolerance, generally between 11V and 14V. This can cause many people problems especially when they have long cable runs, or the battery voltage drops a little (especially late at night), or even if they have a poor power connection. The Majestic UFO XL TV Antenna is designed to work from 9V through to 27V DC, therefore ensuring you will not have any power issues. The TV Antenna is not designed to work on a 24V system if the charging goes above 28V DC.  TV Reception - One important factor in being able to receive TV signal is the signal level. The Majestic UFO XL TV antenna which has the highest gain at 34dB for its 15" size, you can be assured that if there is any chance of signal reception, you will be the one that can get it with the Majestic UFO XL. The Majestic engineering team understands the limitations of both the Marine and Outback environments and developed the Majestic UFO XL specifically for boats, caravans, motorhomes, buses, trucks and RV's.  UHF/VHF/FM/DAB: The UFO XL is capable of receiving signal on different frequencies. Throughout various countries there are UHF and VHF signals for Digital and analog TV, the UFO XL can pick them up and integrate the process in the antenna and amplify them and send a nice clean signal down the cable for your TV. But more importantly the UFO XL can pick up FM and DAB signals and boost this performance. The UFO XL Junction box has Two Outputs and you can use one of them for the FM Signal to give you improved radio performance. The two outputs from the junction box incorporate UHF/VHF/FM/DAB so it does not matter which port you use for the different devices.  Warranty: Majestic products are designed and developed in Australia and exported globally, with over 15 years experience Majestic stands by the quality of our products by providing a 3 year worldwide warranty. Our engineering design team has paid attention to all the important details to ensure that when you purchase a product of this quality and caliber that you can enjoy many years of reliable performance in the toughest conditions where domestic brands will not survive. Upgrading: For those wishing to upgrade, the Junctions boxes are fully interchangeable between the Majestic UFO and the Majestic UFO X so therefore you do not need to change the Junction if you upgrade to the UFO XL higher performance Antenna. Performance: The UFO XL has been re-engineered using the latest in state-of-the-art technology to allow it significantly outperform the previous UFOX Model. So if you are looking for an antenna to give you better performance in fringe areas then the UFO XL will give you the Extreme performance you are looking for.

Wall Mount Bracket with 2-Piece Slide Simple wall plate for easy fitting & removal Majestic LA7C is a simple wall bracket designed to work with both 75mm and 100mm Vesa. Simply lift and the TV comes off, and to mount it just slide it on. Accessories Supplied: Bracket with Screws Color: Black Features: Easily removable Features: Can be used in multiple locations with extra LA10M Screen Size (Diagonal): 10" to 22" Majestic Vesa Size: 75mm or 100mm

Universal Mast Mount Platform for 12"18" Radome Seaview Mast Mounts are designed to have the radar or satdome as close as possible to the mast. Ultra heavy duty mounting feet and rivets are used to secure the Mast Mount to the mast. Adjustable Designed with fore and aft adjustable rails so that you can have the radar as close as possible to the mast. Incredible Strength The solid under body construction not only greatly improves strength but also hides radar cables. On certain models. Accessories Pre-drilled under body allows for flood lights or horns to be mounted on certain models. Compatible Manufacturers: Furuno JRC Koden Lorenz Sitex VDO

Trim Tab Mounting Bracket for SCM-10 - Supports One Light Trim Tab Mounting Brackets Shadow-Caster Trim Tab SCM-TT mounting brackets are the ultimate in mounting accessories for our SCM-4 , SCM-6 and SCM-10 size lights. When your boat cannot support the lights on the transom or you need more light, your Trim Tab will work just as well. Each size is packaged with all the mounting hardware required. They are perfect for adding more light to the transom of your boat, and also work well for customers who may not want to install Shadow-Caster lights on their boat's transom. The bracket is designed to allow for the same great spread and brightness as Shadow-Caster lights mounted on the transom. Specifications: SCM-TT-10: 10" Length (254mm) 316 Stainless Steel Materials 1-Year Warranty Made in the USA WARNING: This product can expose you to chemicals including Urethane which is known to the State of California to cause cancer or other reproductive harm, and LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Trim Tab Mounting Bracket for SCM-6 - Supports One Light Trim Tab Mounting Brackets Shadow-Caster Trim Tab SCM-TT mounting brackets are the ultimate in mounting accessories for our SCM-4 , SCM-6 and SCM-10 size lights. When your boat cannot support the lights on the transom or you need more light, your Trim Tab will work just as well. Each size is packaged with all the mounting hardware required. They are perfect for adding more light to the transom of your boat, and also work well for customers who may not want to install Shadow-Caster lights on their boat's transom. The bracket is designed to allow for the same great spread and brightness as Shadow-Caster lights mounted on the transom. Specifications: SCM-TT-6: 7.2" Length (183mm) 316 Stainless Steel Materials 1-Year Warranty Made in the USA WARNING: This product can expose you to chemicals including Urethane which is known to the State of California to cause cancer or other reproductive harm, and LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Trim Tab Mounting Bracket for SCM-4 - Supports One Light Trim Tab Mounting Brackets Shadow-Caster Trim Tab SCM-TT mounting brackets are the ultimate in mounting accessories for our SCM-4 , SCM-6 and SCM-10 size lights. When your boat cannot support the lights on the transom or you need more light, your Trim Tab will work just as well. Each size is packaged with all the mounting hardware required. They are perfect for adding more light to the transom of your boat, and also work well for customers who may not want to install Shadow-Caster lights on their boat's transom. The bracket is designed to allow for the same great spread and brightness as Shadow-Caster lights mounted on the transom. Specifications: SCM-TT-4: 6.5" Length (165mm) 316 Stainless Steel Materials 1-Year Warranty Made in the USA WARNING: This product can expose you to chemicals including Urethane which is known to the State of California to cause cancer or other reproductive harm, and LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.