Rugged, high-speed, moisture - and solvent-resistant data cables withstand the toughest onboard marine environments. For Lowrance models with 5-pin yellow ethernet connector.

AS-EC-15E Ethernet Cable - 15' Features: 15' Ethernet cable Female connectors on both ends Use AS ECX 30E for cable extension For use with Humminbird Ethernet Systems only Compatibility: 1100 Series™: All models 900 Series™: 958c, 998c SI 800 Series™: 858c, 898c SI 700 Series™: Ethernet Models - 778c HD, 788ci HD, 798ci HD WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Marine Navigation & Instruments, Supplies and Equipment With a wide variety of Marine Navigation equipment and Instruments, we can help you find your location on the waterways, avoid hazards, and be respectful of other boaters. The accessories you have on your boat are important, but very few of them are as valuable as the AIS systems, autopilots, black box modules, and other options you can choose from when you want to make sure you can find your way there and back again while staying away from areas that could mean running aground or experiencing other dangers. We offer many types of navigation equipment, including cameras - network video, ice flashers, and marine monitors.   Depending on where you are going to be boating and what you plan to do with your time on the water, you can also find a fishfinder/sounder - color or a fishfinder/sounder - mono that will be right for you, along with GPS - chartplotters, GPS - fishfinder combos, or a GPS - track plotter. Network accessories and network capable displays are available, and we have a selection of night vision, software, transducers and transducer accessories, and weather fax equipment. If you need radar - stand alone options or radar domes / arrays, look no further than right here, where the selection is good and so are the prices.

ETHEXT-25YL 25 ft. Ethernet Cable Works with: Broadband Sounder-1, GlobalMap 5200C, GlobalMap 5300C iGPS, GlobalMap 7200C, GlobalMap 7300C HD, GlobalMap 8200C, GlobalMap 8300C HD, GlobalMap 9200C, GlobalMap 9300C HD, GlobalMap Baja 540C, GlobalMap Baja 840C, LCX-112C, LCX-113C HD, LCX-27C, LCX-28C HD, LCX-37C, LCX-38C HD, LMS-520C, LMS-522C iGPS, LMS-525C DF, LMS-527C DF iGPS, Navico Expansion Port-1

6' Extension cable fits all 2007 and newer Ethernet-enabled Lowrance units with 5-pin yellow connector

Rugged, high-speed, moisture and solvent-resistant data cable withstand the toughest onboard marine environments. For Lowrance models with 5-pin yellow ethernet connector.

i50 SeaTalkng Instruments - Tridata with Thru-Hull Transducer The i50 Instruments from Raymarine offer boaters an excellent combination of great looks, high performance, and extreme value. Designed to accommodate either stand-alone or fully integrated installations, the i50 instruments feature Raymarine's exclusive SeaTalkng networking for simple installation and bullet-proof reliability. Each instrument offers extra-large digits, razor-sharp LCDs, and red backlighting for outstanding visibility in all lighting conditions. i50 Digital Instrument displays are fully compatible with our i70 Color Multifunction Instrument too. Boaters can now customize their systems with any combination of monochrome LCD, color LCD, and analog instruments as needed. Raymarine also offers the p70 and p70R Color Autopilot controllers which also match our instruments and multifunction displays. For the ultimate in flexibility, the i50 Instruments support SeaTalkng CANBUS networking, as well as our original SeaTalk 1 networking. This makes upgrading older instruments a breeze. Connect your analog depth, speed, and wind transducers directly to the respective instrument display, or use the displays as repeaters for SeaTalkng smart transducer data: the choice is yours. The ultra-sleek design of the i50 line is designed to complement our full line of a-Series, c-Series, and e-Series Multifunction displays, and looks great on the helm of any boat. Each instrument has a low-profile surface mounting kit and silicone rubber sun cover. An optional bracket mounting kit is also available separately. i50 Instruments are designed to operate from 12V DC power and are ultra-efficient drawing less than 1W as repeaters, or 2.4W while hosting a transducer. All of the i50 Instruments are waterproof to IPX6 standards. The i50 instruments are all covered by Raymarine's industry-leading 2-year warranty, upgradeable to 3 years at no charge by registering online within 90 days of purchase. i50 Tridata Instrument  The i50 Tridata is a convenient 3-line instrument that combines the Speed and Depth Instruments functions into one display. This makes the i50 Tridata ideal for installations on helms where space is a premium or as a depth and speed repeater solution for other locations on the boat. Red backlighting for outstanding night-time visibility. SeaTalkng and SeaTalk-1 connectivity for maximum flexibility Use a primary display or as a repeater of i50 depth and speed instruments Built-in depth and speed transducer connections M78713-PZ Nylon Depth Transducer with 45ft cable E70673 ST900/P120 S/T Thru Hull - 13.7m Cable The i50 Tridata's 3-line LCD can show current depth, current speed, distance log, trip log, and water temperature. Additional display modes include maximum speed, average speed, and VMG to windward. Tridats have a count-up timer and 2 race start timers for racers. Tridata's robust alarm functions include a shallow depth alarm, deep depth alarm, shallow anchor alarm, and deep anchor alarm. Features: Ultra-modern design complements Raymarine's latest a-Series, c-Series, and e-Series Multifunction display and instrument systems. Large, crisp LCDs with high contrast for excellent visibility. Red backlighting for outstanding night-time visibility. SeaTalkng and SeaTalk-1 Networking for maximum flexibility. Fully compatible with i70, p70, and p70R Color Instruments and Autopilots. 110mm x 115mm footprint is identical to older Raymarine ST60+ instrumentation making upgrading easy

Lowrance Outboard Cable-Steer Pilot Pack Everything you need in one box to fit an autopilot to your outboard motor, the Outboard Pilot lets you focus on fishing activity while keeping the boat on course. When connected to a Lowrance HDS Gen2 or Gen2 Touch, the Outboard Pilot can steer to a waypoint or along a route, select a turn pattern or simply hold a constant heading. The Lowrance SmartSteer™ user interface allows you to easily switch between electric-steer, trolling-motor control and outboard motor control directly from your HDS display. And, with your HDS display, you can easily convert trails to routes - so you can retrace a previous track and get your boat back to the dock from your fishing area. HDS Units require 3.5 Software Steer your outboard motor to a heading, waypoint, route or cursor, with control from your HDS Gen2 or Gen2 Touch display Lowrance SmartSteer™ interface provides control of your cable-steered outboard motor, as well as the MotorGuide Xi5 Pinpoint electric-steer trolling motor "One-touch" route creation from trails Pre-set turn patterns for more effective fishing/trolling presentations Recommended for single-outboard setups, on boats that are 30 feet and less, in length VRF (Virtual Rudder Feedback).simplifies pilot installation eliminating the need for a rudder position sensor Easy setup.straightforward guide steps you through first-time install Easy-to-install, plug-and-socket connection with no complex terminal wiring Supported by Lowrance Advantage Service program Dash-mount button for one-touch Auto/Standby activation Steer to Heading, Course or Route High efficiency, super-quiet 0.8L hydraulic gear pump Lowrance Outboard Pilot Cable-Steer Pack replaces the manual helm-drive unit Morse 290, Morse 304411 and Teleflex SSC52 cable compatibility Helm-1 is only compatible with the NAC-1.Helm-1 includes variable-voltage feedback interface 2 Year Limited Warranty Package Includes: NAC-1 Autopilot Computer - 000-11769-001 The brains behind the Lowrance Outboard Pilot system. It contains the steering computer and electronics for the drive unit motor and clutch. Helm-1 for Outboard Pilot - 000-11771-001 This drive unit replaces your manual helm-drive unit on single cable installations. Compatible with Morse 290, 304411 and Teleflex SSC52 cables. Includes voltage rudder-feedback sensor, and is only compatible with NAC-1. N2K 4 Way - 000-10996-001 NMEA2000 4-way joiner. Connect four NMEA2000 Micro-C devices to the NMEA2000 Network. N2KEXT-2RD - 000-0119-88 0.6M (2') NMEA 2000® cable for backbone extension or or drop cable to connect an additional network device N2KEXT-6RD - 000-0127-53 1.82M (6') NMEA 2000® cable for backbone extension or drop cable to connect an additional network device N2KEXT-15RD - 000-0119-86 4.55M (15') NMEA 2000® cable for backbone extension or or drop cable to connect an additional network device TR-120-KIT - 000-0127-52 Set of 1 male and 1 female NMEA 2000® terminators MICRO-C POWER CABLE ONLY - NO T CONN - 000-12202-001

Scanpod Helm Pod 3 Instrument Uncut - White With great features, the Helm Pod is a perfect choice for all cockpit configurations. With options to fit radar displays, chartplotters and standard navigation instruments, the Helm Pod is the right choice for you. For Displays & Standard Instruments: 3 x standard navigation instruments & autopilots Usable face 15.35H x 5.5W Features: Universal Helm Fixing - Fits pedestal rails from 25mm to 33.7mm (0.98" - 1.33"). Using a unique clamping system, the Pod can fit rail widths from 178mm (7") upwards. Secure & Watertight Install - Saddle system supports the stainless tubing enabling a secure and rigid fit onto any pedestal and also ensures a watertight seal at cable entry No Drill Fixing Kit - Customised U-bolts fit around rail and through the saddles into the back of the pod eliminating the need for time consuming and awkward drilling of the stainless rail. Hassle Free Install & Service - Fixings fit from back to front cutting their threads into injection moulded ABS inserts designed into the Pod front. This design allows for a quick and safe install and repeat servicing. Increased Protection - Pod seal is manufactured from a high tear strength silicone, it has a very high resistance to heat and UV so you can have confidence that it won't deteriorate over time. Supplied Uncut - As standard you will receive your Scanpod uncut. For larger orders, a factory cutting service is available.

AS ECX 30E Ethernet Cable Extender - 8-Pin - 30' The Ethernet Extension Cable is a 30' cable that allows you to extend the length of your ethernet cables. WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Ethernet Cable - 10 Feet Quickly setup an ethernet connection between two Humminbird ethernet capable units. Available in four lengths. WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Ethernet cable - 20 feet Quickly setup an ethernet connection between two Humminbird ethernet capable units. Available in four lengths. WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

AS EC 30E Ethernet Cable - 30' The Ethernet Cable is a 30' cable that allows the connection of two Ethernet capable units to be connected. WARNING: This product can expose you to chemicals including LEAD which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

Ethernet Cable for M-Series - 25' FLIR's 25' Ethernet Cable is for connecting the FLIR M-Series Cameras to the Joystick Control Unit. Features: Double Shielded RJ-45 LSZH 25' long

Ethernet Cable for M-Series - 50' FLIR's 50' Ethernet Cable is for connecting the FLIR M-Series Cameras to the Joystick Control Unit. Features: Double Shielded RJ-45 LSZH 50' long